150
REAC applications and settings
REAC applications and settings
Splitting Merged Inputs (S-4000M's Split Function)
By using the S-4000M’s Split Function, you can split the merged
inputs (being sent to the M-480) to REAC port 4 of the S-4000M. It
is very convenient when splitting to a monitor console or a multi-
channel recording system.
fig.S4000MSplit.eps
When a REAC splitter (like the S-4000D) is connected to the S-
4000M’s REAC port A, the signal from the M-480 is split.
Notes About the S-4000M’s Split Function
* You can connect a REAC slave device to S-4000M’s REAC port 4 via
a REAC splitter (like the S-4000D). In this case, the physical inputs
of the REAC slave device operate normally but all merged inputs
being sent to the M-480 will being sent out from the physical
outputs.
* If an M-48 is connected to the S-4000M’s REAC port 4, it is not
possible to manage/setup the M-48 from the M-480.
Using the S-4000M's split function makes it unnecessary to use the
M-480's output to REAC for stage-input splitting or recording.
1.
Access the S-4000M CONFIGURATION popup.
fig.S4M_Config1.eps
If the “Split Inputs to PORT4” button in the PORT4 OPTION is
checked, then the S-4000M’s split function is already turned
on. The following steps will not be necessary.
2.
Disconnect the REAC cable connected to REAC port 4 on
the S-4000M.
3.
Move cursor to the Split Merged Inputs button in the
PORT4 OPTION, and press [ENTER].
fig.S4M_SplitChgConf.eps
A confirmation message will ask you to confirm the
operation.
4.
Press [F8 (OK)] to enable the S-4000M’s split function.
Pressing [F7 (CANCEL)] will cancel the operation.
fig.S4M_Config_Split.eps
fig.S4M_Config_Split_Out.eps
5.
Connect the REAC cable to REAC port 4 on the S-4000M.
REAC A or REAC B
MASTER
S-0808
S-4000M
SLAVE
SPLITSLAVE
S-4000S
(32-channel output)
PC Recording
S-4000D
2 3
A
1
4
Merged inputs
Merged inputs (split)
Using S-4000M’s split function
M-480_e.book 150 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
