Roland M-480 - Viewing the Connected M-48 Units

174
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
Viewing the connected M-48 units
You can use the M-48 MANAGER popup to view a list of the M-48
units connected to the M-480's REAC B port.
1.
In the MONITOR section, press [DISP] to access the
MONITOR screen.
fig.ScrMonitor2.eps
2.
Press [F8 (M-48 MANAGER)].
fig.ScrM48Manager_Guide.eps
The M-48 MANAGER popup will appear.
Number of M-48 units
This indicates the number of M-48 units that are connected
to the M-480’s REAC B port.
M-48 list
This lists the M-48 units that are connected to the M-480’s
REAC B port. You can move the cursor to an item in the list
and press [ENTER] to edit that item.
The items shown in the list and the function of the [ENTER]
button are as follows:
ENGINEER’S MONITOR
This shows the unit designated as the Engineer’s Monitor (p.
184)
The function buttons have the following operations:
* M-48 UPDATE is for future updates of the system program. For details
on performing the update, refer to the explanation provided with the
updater.
You can assign a USER button to access the M-48 MANAGER
popup (p. 140).
Accessing the M-48 MANAGER popup
Item
Explanation Function of [ENTER]
NO.
Indicates the order in the
list
Accesses the ARRANGE
UNIT popup
UNIT
NAME
Indicates the unit name Accesses the NAME
EDIT popup
MEMORY
NO.
Indicates the current
memory number
Accesses the M-48
MEMORY popup
2
3
1
1
2
MEMORY
SAFE
If this is checked,
MEMORY SAFE is
activated; recall/store
operations from the M-
480 will be prohibited
Check/uncheck
MUTE If this is checked, the M-
48’s output will be muted
Check/uncheck
[F1 (MUTE CLEAR)] Clears output muting for all M-48 units. This will
be on (light blue) if there are any M-48 units
whose output is muted (p. 175).
[F2 (SETUP)] Accesses the M-48 SETUP popup, where you
can make settings for the M-48 unit at the
cursor location (p. 176).
[F3 (COPY)] Accesses the M-48 COPY popup, where you can
copy settings from the M-48 unit at the cursor
location to another M-48 unit (p. 185).
[F4 (LIBRARY)] Accesses the M-48 LIBRARY popup, where you
can recall/store library data for the M-48 unit at
the cursor location (p. 188).
[F5 (LOAD/SAVE)] Accesses the M-48 LOAD/SAVE popup, where
settings of the M-48 at the cursor location can
be saved to USB memory or loaded from USB
memory (p. 189).
[F6 (SET AS ENG MON)] Specifies the M-48 at the cursor location as the
Engineer’s Monitor (p. 184). This is shown when
nothing is set as the Engineer’s Monitor.
[F6 (ENG MON SETUP)] Accesses the M-48 ENGINEER’S MONITOR
SETUP popup (p. 184). This is shown when an
M-48 unit is set as the Engineer’s Monitor.
[F7 (UPDATE)] Updates the M-48’s system program.
*
[F8 (CLOSE)]
Closes the popup
Item
Explanation Function of [ENTER]
3
M-480_e.book 174 ページ ２０１１年３月２日 水曜日 午前９時２０分