202
Appendix
Appendix
Q (LO, LO-MID, HI-MID, HI)
Steepness of the frequency response curve. (*1)
Value: 0.36–16.00
(*1) Depending on the Type setting of each band, there are
certain combinations for which the Freq, Gain, and Q values
will have no effect, as listed below.
PEAK (Peaking)
Creates a hill or valley in the region of FREQ.
Freq: Valid Gain: Valid Q: Valid
LSV (Low Shelving)
Boosts/cuts the region below FREQ
Freq: Valid Gain: Valid Q: —
HSV (High Shelving)
Boosts/cuts the region above FREQ
Freq: Valid Gain: Valid Q: —
LPF1 (Low-Pass Filter 1)
Passes the frequency region below FREQ
Freq: Valid Gain: — Q: —
HPF1 (High-Pass Filter 1)
Passes the frequency region above FREQ
Freq: Valid Gain: — Q: —
LPF2 (Low-Pass Filter 2)
A sharper response curve than LPF1
Freq: Valid Gain: — Q: Valid
HPF2 (High-Pass Filter 2)
A sharper response curve than HPF1
Freq: Valid Gain: — Q: Valid
BPF (Band Pass Filter)
Passes the frequency region around FREQ.
Freq: Valid Gain: — Q: Valid
NOTCH (Notch Filter)
Removes the frequency region around FREQ
Freq: Valid Gain: — Q: Valid
THRU (Thru)
Passes all frequency regions
Freq: — Gain: — Q: —
fig.AlgoRevwGate.eps
This is a mono-in, stereo-out reverb. It provides a gate that can be
used for gating or ducking, allowing you to cut the reverb during
its decay, or to cut the reverb when the level of the original sound
is high.
Reverb
SIZE (Room size)
Size of the room or hall
Value: 5–40 m
TIME (Reverb time)
Length of the reverberation
Value: 0.1–32.0 s
Pre Dly (Pre-delay time)
Time until the reverb is heard
Value: 0–200 ms
ER Lev (Early reflection level)
Level of the early reflections
Value: -Inf–0.0 dB
DIFFUS (Diffusion)
Amount of scattering for the early reflections
Value: 0–100
DENSITY
Density of the reverb sound
Value: 0–100
LO FREQ DAMP GAIN
Low-frequency attenuation of the reverb sound
Value: -36.0–0.0 dB
LO FREQ DAMP FREQ
Frequency at which the low-frequency region of the reverb
sound begins to be attenuated
Value: 20 Hz–2.00 kHz
HI FREQ DAMP GAIN
High-frequency attenuation of the reverb sound
Value: -36.0–0.0 dB
HI FREQ DAMP FREQ
Frequency at which the high-frequency region of the reverb
sound begins to be attenuated
Value: 200 Hz–20.00 kHz
REVERB+GATE
Input L
Input R
Reverb
DRY
DRY
4 Band EQ
Output L
Output R
Key-In
Gate
M-480_e.book 202 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
