203
Appendix
Appendix
HI CUT FREQ
Frequency at which the high-frequency region of the reverb
sound will be cut
Value: 200 Hz–20.00 kHz
WET (Wet Level)
Level of the reverb sound
Value: -Inf–+6.0 dB
DRY (Dry Level)
Level of the original sound
Value: -Inf–+6.0 dB
EQ
EQ SW (EQ switch)
Turns the EQ on/off
Value: OFF, ON
EQ ATT (EQ attenuator)
Attenuator for the EQ
Value: -42.0–+6.0 dB
TYPE (LO, LO-MID, HI-MID, HI)
Filter type. (*1)
Value: PEAK, LSV, HSV, LPF1, HPF1, LPF2, HPF2,
BPF, NOTCH, THRU
GAIN (LO, LO-MID, HI-MID, HI)
Gain. (*1)
Value: -15.0–+15.0 dB
FREQ (LO, LO-MID, HI-MID, HI)
Frequency. (*1)
Value: 20 Hz–20.00 kHz
Q (LO, LO-MID, HI-MID, HI)
Steepness of the frequency response curve. (*1)
Value: 0.36–16.00
(*1) Depending on the Type setting of each band, there are
certain combinations for which the Freq, Gain, and Q values
will have no effect, as listed below.
PEAK (Peaking)
Creates a hill or valley in the region of FREQ.
Freq: Valid Gain: Valid Q: Valid
LSV (Low Shelving)
Boosts/cuts the region below FREQ
Freq: Valid Gain: Valid Q: —
HSV (High Shelving)
Boosts/cuts the region above FREQ
Freq: Valid Gain: Valid Q: —
LPF1 (Low-Pass Filter 1)
Passes the frequency region below FREQ
Freq: Valid Gain: — Q: —
HPF1 (High-Pass Filter 1)
Passes the frequency region above FREQ
Freq: Valid Gain: — Q: —
LPF2 (Low-Pass Filter 2)
A sharper response curve than LPF1
Freq: Valid Gain: — Q: Valid
HPF2 (High-Pass Filter 2)
A sharper response curve than HPF1
Freq: Valid Gain: — Q: Valid
BPF (Band Pass Filter)
Passes the frequency region around FREQ.
Freq: Valid Gain: — Q: Valid
NOTCH (Notch Filter)
Removes the frequency region around FREQ
Freq: Valid Gain: — Q: Valid
THRU (Thru)
Passes all frequency regions
Freq: — Gain: — Q: —
GATE
GT SW (GATE switch)
Turns the gate on/off
Value: OFF, ON
GT MODE (Gate mode)
Value
GATE: Sound lower than the THRESHOLD level will
be attenuated by the amount specified by
RANGE
DUCK: Sound that exceeds the THRESHOLD level
will be attenuated by the amount specified
by RANGE
THRE (Threshold level)
Threshold level of the gate
Value: -80.0 –0.0 dB
RANGE
Range of the gate
Value: -80.0 –0.0 dB
ATK (Attack time)
Attack time of the gate
Value: 0.0–800 ms
REL (Release time)
Release time of the gate
Value: 0–8000 ms
HOLD (Hold time)
Hold time for the gate
Value: 0–8000 ms
M-480_e.book 203 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
