EasyManua.ls Logo

Roland M-480 - Monitor Section and USB Memory Connector

Roland M-480
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
Explanation of the panels
Explanation of the panels
EQUALIZER area
fig.ChEdtEQ.eps
In this area you can operate the 4-band EQ that is provided on
CH1–48, AUX1–16, MTX 1–8, and MAIN L/R/C.
[ON] button
This button turns the EQ on/off. It will light if the EQ is on.
[DISP] button
This accesses the EQUALIZER popup where you can make
detailed settings. The button will light red when the popup
is shown.
Q knob
This adjusts the Q of each band.
FREQ knob
This adjusts the frequency of each band.
GAIN knob
This adjusts the gain of each band.
When the GATE/EXPANDER popup (p. 71), COMPRESSOR popup
(p. 76), or LIMITER popup (p. 80) is displayed, the parameters of
the gate/expander, compressor, or limiter can be adjusted using
the Q knobs, FREQ knobs, or GAIN knobs.
PAN area
fig.ChEdtPan.eps
PAN knob
For CH 1–48 and RTN 1L–6R, this adjusts the pan. For AUX 1–
16, MTX 1–8, MAIN L/R, it adjusts the balance.
AUX/MTX SENDS area
fig.ChEdtAux.eps
In this area you can adjust the send level to the AUX/MTX buses.
[AUX1]–[AUX16] buttons
These buttons select the send-destination bus. AUX or MTX
can be selected on CH and RTN, MTX can be selected on AUX
and MAIN.
To select an MTX as the send-destination, hold down one of the
[AUX1]–[AUX8], and press its right side [AUX9]–[AUX16].
You can turn the corresponding send switch on/off by holding
down [SHIFT] and pressing [AUX1]–[AUX16].
•[
DISP] button
This button accesses the AUX (MTX) SENDS popup. It will
light red when the popup is shown.
LEVEL knob
This adjusts the send level to the selected AUX/MTX bus.
If a MTX channel is selected, this will adjust the send levels from
AUX1–16 to MTX.
If AUX/MTX buses are stereo-linked, selecting the odd-
numbered AUX/MTX bus will let you adjust the send pan, and
selecting the even-numbered AUX/MTX bus will let you adjust
the send level.
•[
SENDS ON FADER] button
This button turns SENDS ON FADER mode on/off. It will blink
if SENDS ON FADER mode is on.
“Using the SENDS ON FADER” (p. 45)
7
8
8
M-480_e.book 24 ページ 2011年3月2日 水曜日 午前9時20分

Table of Contents

Other manuals for Roland M-480

Related product manuals