Roland M-480 - Effect Input;Output Settings

99
Effects and GEQ
Effects and GEQ
IN meters
These indicate the input level to the effect.
Effect name indication
The upper line shows the library name, and the lower line
shows the effect type name.
The icon indicates the input/output configuration for the
effect:
● Mono-in/Stereo-out
fig.ScrFxTypeMS.eps
This is a monaural-input/stereo-output type effect. These
effects are used mainly in a send/return configuration.
If you specify two input-sources, the two inputs will be mixed to
mono before being input.
● Dual mono
fig.ScrFxTypeMM.eps
This allows the effect to be used as two monaural effects.
These effects are used mainly for insertion in a channel.
● Stereo-in/Stereo-out
fig.ScrFxTypeSS.eps
This is a stereo-input/stereo-output type effect. These effects
can be inserted into a stereo channel, or used in a send/
return configuration with stereo-linked AUX channels.
OUT meters
These indicate the output level from the effect.
LR LINK button
This links the parameters between the L and R sides.
The following effect types support LR LINK:
• GEQ x2
• DELAY x2
• P.SHIFTER x2
• CH STRIP x2
• SDE-3000 x2
• SPH-323 x2
BYPASS L, R buttons
These buttons turn the bypass on/off. When these are on,
the input signal will be “thru-ed” to the output.
You can also make the setting for switching bypass on or off
from a USER button (p. 140).
FX DESTINATION SELECT popup button
These select the output-destination for the effect. The
current output-destination is shown on the button. When
you move the cursor to the button and press [ENTER], the FX
DESTINATION SELECT popup will appear.
If more than one output-destination channel are exist, the
lowest number channel is shown.
If you select insertion into a channel in the FX INSERT/SOURCE
SELECT popup, the corresponding FX DESTINATION SELECT
button will be unavailable. If you want to re-enable the FX
DESTINATION SELECT button, select an input-source other than
Insert in the corresponding FX INSERT/SOURCE SELECT popup.
4
5
6
7
8
9
Effect input/output settings
The FX INSERT/SOURCE SELECT popup and the FX DESTINATION
SELECT popup are used to select the input-source and output-
destination for the effect.
1.
Access the EFFECTS screen, and display the FX1–6 tab.
fig.ScrFXInSelBtn.eps
2.
Move the cursor to the FX INSERT/SOURCE SELECT popup
button L or R of the desired effect, and press [ENTER].
fig.ScrFXInSelGuide.eps
The FX INSERT/SOURCE SELECT popup will appear.
Current insert-destination/input-source indication
This indicates the current insert-destination channel or the
input-source channel for the effect.
Accessing the FX INSERT/SOURCE SELECT
popup
FX INSERT/SOURCE SELECT popup button
21 3
1
M-480_e.book 99 ページ ２０１１年３月２日 水曜日 午前９時２０分