Roland Metaza MPX-90 - How to Replace the Head

100
5-6 Head Replacement
Chapter 5 Maintenance and Adjustment
How to Replace the Head
MPX-90 Head Manager is used for the head replacement operation.
The pattern shown in the gure is struck during the head replacement operation. You need to prepare a test
print material (brass), which is supplied with a replacement head (MPH-90), or a material equal to or larger
than 60 mm (2.3 in.) x 60 mm (2.3 in.).
A replacement head is sold separately. Consult your authorized Roland DG Corp. dealer.
 Do not stop the replacement operation halfway.
 Do not use the head of which the marking pin is worn out.
 Do not use the head which is detached from the machine.
Procedure

From [Start] menu, click [All Programs] (or [Programs]) → [MPX-90 Head Manager] →
[MPX-90 Head Manager].
MPX-90 Head Manager starts.

Switch on the power to the machine.
 P. 30, "Switching On the Power"

Click [Readjust Pin].
Follow the on-screen instructions to
perform adjustment for the pin.
Set material using the adhesive sheet
and table.
 P. 36, "Loading Material Using the Adhesive
Sheet"
Print the adjustment pattern using the
head cap.
 P. 36, "Loading Material Using the Adhesive
Sheet"
If the adjustment pattern fails to be
printed, see the sections given below.
 P. 104, "The printed location isn't where
desired," p. 105, "Striking is performed, but
nothing is printed"
Adjustment
pattern