16
1-2 Names and Functions
Chapter 1 Getting Started
Head (MPH-90)
Printing is performed on material using with a
marking pin. Diamond is attached to the tip of
the marking pin. Since the head is a consum-
able part, replace it at an appropriate timing.
P. 99, “The Replacement Cycle for the Head”
Material Retainers
This is used to x material on a table. Material is
placed on the adhesive sheet, which then holds
the material in place. This lets you immobilize
objects without having to use commercially
available tape or the like.
P. 36, “Loading Material Using the Adhesive
Sheet”
This is a vise made of plastic, and secures
material in place by clamping it. This makes
it possible to immobilize material that cannot
be secured using the adhesive sheet, such as
items having a curved bottom surface. The act
of securing an item in place also accurately de-
termines the center position in the horizontal
direction.
P. 41, “Loading Material Using the Center Vise”
Adhesive sheet
Center vise
Marking pin
To Next Page
Loading...
