Roland Metaza MPX-90 - Page 36

34
3-2 Getting Ready
Chapter 3 Making Prints
Cross-section of printing material
When using an adhesive sheet or a center vice.
 There must be no unevenness on the print surface. *4
*4
Materials that cannot be used are those of which unevenness comes into contact with the moving part of the
machine when material is set or when printing is made.
When using an adhesive sheet.
 The back surface must be at, with no dierence in level.
Without a head cap
The printed surface must be level.
Edge of the material is
too high.
Back surface
is curved.
Back surface
is uneven.
Surface to print
is not straight.
L-shape
Not OK
Not OK
Not OK
Not OK
Not OK