Procedure
Enter the text.
P. 50, “Step3 : Enter the Text”
Click .
The [Properties] dialog box appears.
Click the [Fill and Contour]
tab.
Select the [Fill] check box.
Select [Fill] or [Island Fill].
When you select [Island Fill], you need
to enter Pitch as well. Pitch is the interval
between adjacent lling lines.
Click [OK].
The text is lled.
Important!
When you make a print with a lot of lines (Island Fill, etc.) on aluminum material and the like, the unevenness
of the material surface is increased, and consequently the head cap becomes worn out faster. Check the state
of the head cap regularly so that it can be replaced at an appropriate timing.
P.98, “The Replacement Cycle for the Head Cap”
To Next Page
Loading...
