Roland Modela MDX-40 - Side View; Operation Buttons

1-1 Machine Feature
Chapter 1 Introduction
18
USB connector
Connect a USB cable
(sold separately) to this
connector.
Main Power switch
This is the machine's main power
switch.
Power connector
Connect the supplied power cord to this
connector.
Sensor connector
Connect the supplied sensor
cable to this connector.
Side view
Operation buttons
Sub power button
Press this button to start the machine when
the main power switch is on.
VIEW button
Press this button to temporarily stop the ma-
chine and move the cutter to the top position.
To restart the machine, press the button once
again.
TOOL-UP/TOOL-DOWN button
These buttons move the spindle head up and
down.
To stop cutting, pause the machine, then press
these two buttons at the same time. This de-
letes all data sent to the machine.
Power light
Lights up when the machine is oper-
ating.
MODELING light
This lights up when the Sub power but-
ton is pressed.
SCANNING light (optional)
This lights up while using the optional
scanning unit.
VIEW light
Lights up when the machine is tempo-
rarily stopped. While the light is on, the
machine does not receive processing
data.
Expansion connector
Expansion connector