Roland Modela MDX-40 - Setting the Cutting-Start Location

3-3 Installing a Tool and Setting the Cutting-start Location
Chapter 3 Operation
32
Setting the Cutting-start Location
1. Set the Z origin point.
➊
Close the front cover.
Press the VIEW button to make the VIEW light go out.
➋
Using the operation panel screen, press the button in the
figure.
➌
Bring the tool lightly into contact with the surface of the
workpiece while rotating the spindle.
➍
At the location where the workpiece surface begins to be
cut slightly, stop rotating the spindle.
➎
Select [Set the Z origin here].
Click [Set].
The Z origin point has now been set.
2. Set the XY origin point.
➊
Move the spindle to the cutting-start location.
Move the spindle to a location slightly above the workpiece.
➋
Select [Set the XY origin here].
Click [Set].
The XY origin point has now been set.
Table
Workpiece
Workpiece