94
Editing a song
Moving sequence data (Move)
Here's how you can move the specified region of performance data. The data recorded
in the move-source region will be replaced by rests. This editing command is useful in
situations like the following.
• When you want to move or transpose a phrase (when using Piano Roll editing)
• When you want to move sequence data from one track to a different track (when
using Sequence editing)
1.
Specify the editing region as described in
Using the PIANO ROLL EDIT
screen to edit a MIDI track
(p. 90) or
Using the SEQUENCE EDIT screen
to edit
(p. 91).
This specifies the region of sequence data that will be moved.
2.
Access the
SELECT SEQUENCE EDIT COMMAND popup
(p. 225), and
choose “Move...”
The
MOVE popup
(p. 227) will appear.
3.
Set the parameters.
Specify the move-destination for the selected data.
•To
Specify the new time to which the note message(s) will be moved.
• Transpose
Specify the new note number to which the note message(s) will be moved.
• To Track
Specify the track to which the data will be moved. If you're moving more than one
track, this parameter is invalid.
• Mode
Specify what will happen if performance data exists at the move-destination.
4.
Press (Execute).
The specified region of data will be moved.
Setting
Explanation
Mix
The moved data will be merged (combined) with the data existing at
the destination.
Replace
The moved data will replace (overwrite) the data existing at the des-
tination.
For details on all of the
Move-related parameters
and settings, refer to the
MOVE popup (p. 227).
The Destination Note
parameter is available if you
accessed the MOVE popup
from the PIANO ROLL EDIT
screen.
The Destination Track
parameter is available if you
accessed the MOVE popup
from the SEQUENCE EDIT
screen.
If the track(s) being moved
include audio tracks, the Mode
parameter is fixed at Replace.
ECS05_manual_e.book 94 ページ ２００５年１１月３０日 水曜日 午前１１時１４分
To Next Page
Loading...
