Effect Block
A-23
MV-8800 Appendices
About MIDI
Effect Block
SpecificationsMIDI Implementation
Gate
This shuts off the signal. It also provides the characteristic
effect in gated reverb, which cuts off reverb sounds while
they are still being produced, ducking reverb, and other such
effects.
Gate (Gate Switch)
Value: Off, On
This turns on and off the gate function that cuts the
output of the reverb sound based on the volume of the
source sound.
•
The effect block switch (press [F5](Fx On/Off) to change) is
shared with the Reverb block. If you want to turn off only
the Gate, turn the Gate switch Off.
Mode
Threshold
Value: 0–100
Sets the input volume level at which starts closing the
gate to cut the reverb sound.
Attack
Value: 1–100
Sets the time it takes the gate fully opens after being
triggered.
Hold
Value: 1–100
Sets the time it takes the gate starts closing after the
instant the source sound goes under the threshold level.
Release
Value: 1–100
Sets the time it takes the gate fully closes after passes
by the hold time.
fig10-11e
■
Other effect blocks
•
EQ (3 Band EQ) (p. 18)
Value
Explanation
Gate
(Gate Reverb) When the source volume falls below
a certain level, the gate closes, giving the effect of
the reverb sound being cut with a gate reverb.
Duck (Ducking Reverb) When the source volume gets
high enough, the gate closes, which gives a
ducking reverb-type effect. Stop the reverb sound
only when input loud sound so that prevent the
play sound become unclear.
Release
Hold
Attack
Close
Threshold
Open
Input signal
Gate
MV-8800_a_e.book 23 ページ ２００６年１１月１０日 金曜日 午前１０時１９分
To Next Page
Loading...
