Effect Block
A-38
MV-8800 Appendices
Distort (Stereo Distortion)
This is a virtual analog distortion that reproduces the sound
of compact effects for guitars.
Tone
Value: 0–100
This adjusts the brightness of the sound. When this
value is set high, the distortion is loud and bright.
Level
Value: 0–100
Sets the output volume. Distortion also increases the
volume levels; you can use this parameter to control it.
Dist
Value: 0–100
Sets the degree of distortion. At the source sound with
low volume levels, there may be no distortion, even with
the value increased.
•
Two distortion units are linked and arranged in parallel (left
and right) to make the algorithm stereo compatible. If you
can’t adjust the tone enough with the Tone control, use the
equalizer at the next stage.
■
Other effect blocks
•
EQ (3 Band EQ) (p. 18)
•
NS (Noise Suppressor) (p. 21)
16 Stereo Distortion
MV-8800_a_e.book 38 ページ ２００６年１１月１０日 金曜日 午前１０時１９分
To Next Page
Loading...
