Roland RD-500 - Page 19

4. Select the Tone for the LOWER Part.
a. While holding down the LOWER button, press a Tone Selection button to select a Tone
Group.
When only the LOWER button is lit, you can select the Tone Group by simply pressing the
relevant Tone Selection button.
Press the VARIATION button (the indicator will light).
Press the LOWER button (the indicator will flash).
Select the Tone number you want using the INC/DEC buttons or the VALUE slider.
Press the VARIATION button again (the indicator will go out).
cans
* Even after pressing the VARIATION button, you can change Tone Groups by using Tone Selection
buttons.
* If you press two Tone Selection buttons while the SPLIT button is being lit, the Tone pressed
earlier will be assigned to the INT UPPER Part, while the Tone pressed later will be assigned to
the INT LOWER Part.
19