Roland RD-500 - Setting the Detune Pitch

@ Parameters that can be selected for the DEPTH button:
dPk- Chorus Depth: 0— 127
rc Al bk Chorus Rate: 0— 127
Set the depth or rate of the Chorus effect.
@ Parameters that can be selected for the TIME button:
: Lb FE Pp Reverb Level: O— 127
k
if}
Reverb
Time:
O—127
Set the level or time of the reverberation effect.
In some Tones, Delay effect is set instead of Reverb. If so, Reverb Time / Level setting will actually
be Delay Time / Level setting.
@ Parameters that can be selected for the TREMOLO button:
d P
bE
Tremolo
Depth:
0
—
30
cr Ak Tremolo Rate: 0—127
Set the depth or rate of the Tremolo effect.
* increasing the value of Tremolo Depth may cause noise. If this happens, change it to an
appropriate value.
i Setting the Detune Pitch
When the same Tone is assigned to the INT LOWER/INT UPPER Parts in the Layer made, you can set
the pitch difference between them.
GRAND 1. GRANO 2 E.GRAND -MKE-20
Ce)
REV TOUCH “JNGICATOR © LOCAL pes
pinobesepiano MAAS
1. Select the Function mode.
2. Press the DETUNE button (the indicator will light).
3. Set the pitch with the INC/DEC buttons or the VALUE slider.
Valid Pitch : -10 — 10
30