Roland RD-500 - Page 44

44
@ Sending Bank Select Messages
. Select the Bank Select Transmit mode.
To transmit MSB, press the BANK M button (the indicator will light). To send LSB, press the PGM C
button while holding the BANK M button down (the indicator of the PGM C button will light).
. Press the LOWER or UPPER button to select the Part to which you wish to transmit the
messages.
. Set the Bank Select Number.
Specify the Bank Select number using the INC/DEC buttons, VALUE slider or Numerical Keys.
Bank Select Number: 0 — 127/OFF
. When you finish setting the number, press the BANK M or PGM C button (the indicator will
go out).
* The Bank Select number you have set is transmitted together with the Program Change message.
When OFF is selected, no Bank Select message will be transmitted.