Roland RD-500 - Page 54

@ Position Indicators
You can set button indicators to remain dimly lit even when the function is actually off! This function
may be useful when working in a dark place. The brightness of each indicator can be set .
* The settings of the Position Indicators can be written into a Setup Memory.
: (2) “cries 3 E.GRANO | MKS-20
: al Bel
WOKATOR LOCAL BUX
tell gs Balj Re
ORTUNE BITCH RX CH. ZONE,
. Press the FUNC button.
. Press the INDICATOR button.
. Select the buttons which you wish to remain lit.
Each time you press a button, the corresponding indicator will be dimly lit or dark. If you wish the
indicator to be lit even when the function of the button is turned off, make sure its on here.
. Adjust the brightness of the indicator.
Using the INC/DEC buttons or VALUE slider, adjust the brightness of the indicator.
Position Indicator Brightness Range: 0 — 2.
. Press the FUNC button.
m@ Sending RD-500 Data to a Sequencer — Bulk Dump
54
If you wish to record the settings (Exclusive messages) of the RD-500 into an external sequencer for
storage, use the Bulk Dump procedure.
EQUALIZER LAYER SsPur GRAND 1 GRAND 2 E.GRAND MKS~20
DETUNE PITCH RACH ZONE KEY TOUCH “INORCATOR |
CHORUS LEVEL VARIATION RHODES | EFKANO
Deere CONTAC. TRANSPORE TREMOLO . . .
LOWER UPPER SYNTH PERCUSSION
INTERNAL SOUNDS
1. Press the FUNC button.
2. Press the BULK button (the indicator will light).
3. Start recording on the sequencer.
4. Press the YES(DEC) button, and the Exclusive messages will be transmitted.