Roland RD-500 - Multi-Timbral Mode Configuration

5. When the display responds as shown below, the transmission is complete. Stop recording
on the sequencer.
Start = = ai B
The RD-500 data has now been transferred into the sequencer.
@ Multi-Timbral Mode
The RD-500 can be used as an 8 Part Multi-timbral sound module.
Sequencer RD-500
ry
=
| Part 6 (Rhythm Set)
INT LOWER part
INT UPPER part
MIDI Keyboard
EO
* A Rhythm Set of PERCUSSION Tone Group is assigned to Part 6.
This section describes how to set the other 6 Parts as well as the INT LOWER/INT UPPER Parts.
@ Select the Multi-timbral Mode
VALUE
GRAND 1. GRAND 2 £.GRAND MKS-20
eae joel b Beil § Bae
KEY TOUCH. INDICATION ©
Lf
RHODES | E.PIANO HANS: ORGAN
: DOWh REND. UP
MOLO,-. SENSITAATY. BEND
SYNTH STRINGS BASS PERCUSSION
; | cab in
THE ATTACK DECAY PRLEASE SrOHT
hoe : _ INTERNAL SOUNDS
1. Press the FUNC button.
2. Press the RX CH button as many times.as necessary to get the following display:
[| ALE |e|_oFF |
55