Roland RD-500 - Page 57

@ Setting the Volume of a Part
SLAYER SPUN 9-25. ;GRAND 7".GRAND 2° E.GRAND ‘MKs-zo
pO CH ZONE REY TOUCH INDICATOR _ OCA
2 A REVEL. -VARRATION =< RHODES - EPIANO HANG onGaN
onl 5 Mat 5 orl
SENSIIMITY REND DOWN BEND UP
SYNTH STRINGS BASS PERCUESION
co eet fl aa Nee
ATEACe TECAY RELEASE
@ _ INTERNAL SOUNDS
1. Select the Part to be edited using the INC/DEC buttons or the VALUE slider.
2. While holding down the LEVEL button, adjust the volume (0—127) using the INC/DEC
buttons or the VALUE slider.
* While the LEVEL button is held down, the display shows the volume you have set.
* Far a detailed explanation about how to set the volume of INT LOWER/INT UPPER Parts, see page
20.
NOTE........... Gaus sanvaansisnansdasccdtasectsestavstecssoaincecacecots sesasedcwuosussesuicoussens suselsvoesesssccebessnsauvesseseoesd
When you are playing INT LOWER/INT UPPER Part from the keyboard while playing the Parts 1 — 6
on a sequencer, changing Tones in the INT LOWER/INT UPPER Part will automatically change the
overall effect (Chorus or Reverb). To change Tones without affecting the overall effect, do as follows.
1. Press the LAYER button and make sure that the indicator is lit.
2. Set the effect (Chorus or Reverb) in the INT UPPER Part.
3. Turn off the UPPER button, then play the INT LOWER Part from the keyboard.
* The Tones assigned to Parts 1—6 will be played according to the basic settings, since the
parameter settings for each Tone Group are invalid.
57