Roland RD-500 - Panic Function and Factory Reset

@ Panic function
This returns all devices, including those connected by MIDI, to the normal condition. It is used to
stop “stuck” notes from continually sounding.
Press the FUNC button while holding down the DEC button.
aa Sia (i Eel } Bicol
TCH ARCH zo WEY INDICATOR. LOCAL
SxoRUS LEVEL VARIATION RHODES. EPIANO HAAG -on
Rice Flea Mca
‘DEP Tt. " a 0. SENSFINITY BEND DOWN. :
REVERS LOWER. UPPER, SYNTH STRINGS ~ BASS -PERCUSSION
coc il acl
Hold down
When the buttons are pressed down for a short time (less than one second), they transmit key off/hold
off messages over the channels where the internal sound source mute and key on/hold on are
applied. When the button is held down for more than one second, the following messages are
transmitted over all channels:
All note off (note off velocity 64)
Pitch bender center
Channel aftertouch 0
modulation 0
Hold 1 0
Volume 127
@ To retrieve the Factory Settings for all the Setup Memories
58
1. Switch off the unit.
2. Switch on the unit while holding down 1 and 8 in the NUMBER (Setup Memory) buttons.
The display responds as follows :
Pa ee
3. To retrieve the Factory Settings for all the Setup Memories, press the YES (DEC) button.
To cancel it, press the NO (INC) button.