Roland RD-600 - Advanced Troubleshooting; Sequencer Operation Troubleshooting

SS 2 ETE TN ANE TP TC EE a EE BPE EI BEE PEE NIG TFET SID SS IE IES TESS SINEAD FEN SUOMI INC TET STE | PPO aTIT TRETUPRO GES KIS Tn sates best
Pitch is incorrect
* Are the transpose settings of the TX UPPER / LOWER parts set correctly? (p.42)
* Is the pitch bender being operated? (p.10)
* If control change number 1 (modulation) is assigned to the pedal, check the position of the
pedal. (p.50)
Cannot transmit program change / bank select messages
* Is the Program Change / Bank Select setting turned OFF? (p.25, 26)
* Is the Transmit Ch. setting correct? (p.40)
When using a sequencer
No sound
* If the receive channel of the internal part corresponding to the INT part is turned OFF, there
will be no sound. Change the receive channel setting. (p.45)
Cannot record a performance
* If the part switch of the TX part is turned off, your performance data will not be output from
MIDI. (p.12)
Performance is recorded on the wrong channel
* Are the receive channel and transmit channel set correctly? (p.40, 45, 47)
When you play the RD-600 the sound is wrong / notes are sounded twice
¢ If the Thru function of the sequencer is turned on and a part switch of an INT part is turned
on, each note will be sounded twice on the internal sound source. Turn off the part switches
of the INT part. (p.12, 47)
61