Roland RS-5 - 29: Distortion→Chorus; 30: Distortion→Flanger; 31: Distortion→Delay

101
Chapter 6. Effect Settings
Chapter 6
Level (Output Level)
Adjust the output level.
Value: 0–127
29: DISTORTION→CHORUS
This effect connects distortion and chorus in series. The
parameters are essentially the same as “26: OVERDRIVE →
CHORUS,” with the exception of the following two.
OD Drive → Dist Drive (Specify the amount of distortion.)
OD Pan → Dist Pan (Specify the stereo location of the
distortion sound.)
fig.MFX-29
30: DISTORTION→FLANGER
This effect connects distortion and flanger in series. The
parameters are essentially the same as in “27: OVERDRIVE
→ FLANGER,” with the exception of the following two.
OD Drive → Dist Drive (Specify the amount of distortion.)
OD Pan → Dist Pan (Specify the stereo location of the
distortion sound.)
fig.MFX-30
31: DISTORTION→DELAY
This effect connects distortion and delay in series. The
parameters are essentially the same as in “28: OVERDRIVE
→ DELAY,” with the exception of the following two.
OD Drive → Dist Drive (Specify the amount of distortion.)
OD Pan → Dist Pan (Specify the stereo location of the
distortion sound.)
fig.MFX-31
L in
R in
Chorus
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
L in
R in
Flanger
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
L in
R in
Delay
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback