Roland RS-5 - 32: Enhancer→Chorus; 33: Enhancer→Flanger

102
Chapter 6. Effect Settings
32: ENHANCER→CHORUS
This effect connects an enhancer and a chorus in series.
fig.MFX-32
Enhancer Sens (Enhancer Sensitivity) #1
Adjust the sensitivity of the enhancer.
Value: 0–127
Enhancer Mix (Enhancer Mix Level)
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Value: 0–127
Chorus Delay (Chorus Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
Value: 0.0–100 [ms]
Chorus Rate
Adjust the modulation speed of the chorus effect.
Value: 0.05–10.00 [Hz]
Chorus Depth
Adjust the modulation depth of the chorus effect.
Value: 0–127
Chorus Bal (Chorus Balance) #2
Adjust the volume balance between the enhancer sound that
is sent through the chorus and the enhancer sound that is not
sent through the chorus. With a setting of “D100:0W,” only
the enhancer sound will be output. With a setting of
“D0:100W,” only the enhancer sound that is sent through the
chorus will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
33: ENHANCER→FLANGER
This effect connects an enhancer and a flanger in series.
fig.MFX-33
Enhancer Sens (Enhancer Sensitivity) #1
Adjust the sensitivity of the enhancer.
Value: 0–127
Enhancer Mix (Enhancer Mix Level)
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Value: 0–127
Flg Pre Dly (Flanger Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
Value: 0.0–100 [ms]
Flg Rate (Flanger Rate)
Adjust the modulation speed of the flanger effect.
Value: 0.05–10.00 [Hz]
Flg Depth (Flanger Depth)
Adjust the modulation depth of the flanger effect.
Value: 0–127
Flg Feedback (Flanger Feedback Level)
Adjust the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Value: -98– +98 [%]
Flg Balance (Flanger Balance) #2
Adjust the volume balance between the enhancer sound that
is sent through the flanger and the enhancer sound that is not
sent through the flanger. With a setting of “D100:0W,” only
the enhancer sound will be output. With a setting of
“D0:100W,” only the enhancer sound that is sent through the
flanger will be output.
Value: D100:0W–D0:100W
Chorus
L in
R in
L out
R out
Mix
Mix
Enhancer
Enhancer
Balance W
Balance W
Balance D
Balance D
Feedback
Flanger
L in
R in
L out
R out
Mix
Mix
Enhancer
Enhancer
Balance W
Balance W
Balance D
Balance D