Roland RS-5 - 36: Flanger→Delay; 37: Chorus→Flanger

104
Chapter 6. Effect Settings
Delay HF Damp
Adjust the frequency above which delayed sound fed back to
the delay input will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Value: 200–8000 [Hz], BYPASS
Delay Bal (Delay Balance) #2
Adjust the volume balance between the chorus sound that is
sent through the delay and the chorus sound that is not sent
through the delay. With a setting of “D100:0W,” only the
chorus sound will be output. With a setting of “D0:100W,”
only the chorus sound that is sent through the delay will be
output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
36: FLANGER→DELAY
This effect connects a flanger and a delay in series.
fig.MFX-36
Flg Pre Delay (Flanger Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
Value: 0.0–100 [ms]
Flg Rate (Flanger Rate)
Adjust the modulation speed of the flanger effect.
Value: 0.05–10.00 [Hz]
Flg Depth (Flanger Depth)
Adjust the modulation depth of the flanger effect.
Value: 0–127
Flg Feedback (Flanger Feedback Level)
Adjust the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Value: -98– +98 [%]
Flg Balance (Flanger Balance) #1
Adjust the volume balance between the direct sound and the
flanger sound. With a setting of “D100:0W,” only the direct
sound will be output. With a setting of “D0:100W,” only the
flanger sound will be output.
Value: D100:0W–D0:100W
Delay Time
Adjust the time delay from when the direct sound begins
until the delay sound is heard.
Value: 0.0–500 [ms]
Delay Feedback (Delay Feedback Level)
Adjust the proportion (%) of the delay sound that is fed back
into the delay input. Negative (-) settings will invert the
phase.
Value: -98– +98 [%]
Delay HF Damp
Adjust the frequency above which delayed sound fed back to
the delay input will be cut. If you do not want to cut the high
frequencies of the delay feedback, set this parameter to
BYPASS.
Value: 200–8000 [Hz], BYPASS
Delay Bal (Delay Balance) #2
Adjust the volume balance between the flanger sound that is
sent through the delay and the flanger sound that is not sent
through the delay. With a setting of “D100:0W,” only the
flanger sound will be output. With a setting of “D0:100W,”
only the flanger sound that is sent through the delay will be
output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
37: CHORUS→FLANGER
This effect connects a chorus and a flanger in series.
fig.MFX-37
Feedback
Delay
L in
R in
L out
R out
Balance W
Balance W
Balance D
Balance D
Flanger
Balance W
Balance W
Balance D
Balance D
Feedback
Feedback
Flanger
L in
R in
L out
R out
Balance W
Balance W
Balance D
Balance D
Chorus
Balance W
Balance W
Balance D
Balance D