Roland RS-5 - Setting the Reverb Depth of each Individual Part

109
Chapter 6. Effect Settings
Chapter 6
Type (Reverb Type)
You can choose from 8 types of reverb.
Value:
ROOM1–3: Simulates the reverberation of room
interiors. It produces a well-defined
and spacious reverberation.
HALL1, 2: Simulates the reverberation exhibited
by halls. They provide a deeper
reverberation than the Room reverbs.
PLATE: Simulates a plate reverb unit (a type of
artificial reverb that utilized a metal
plate).
DELAY: A standard delay, that produces echo
effects.
PANNING DELAY: This is a special delay in which the
delayed sound alternates between left
and right. It is effective when you are
listening in stereo.
Character (Reverb Character)
Selects the type of reverb. 0–5 are reverb effects, and 6 and 7
are delay effects.
Value: 0–7
Pre-LPF (Reverb pre-low pass filter)
A low pass filter can be applied to the sound coming into the
reverb to cut the high frequency range. Higher values will
cut more of the high frequencies, resulting in a more mellow
reverberation.
Value: 0–7
Level (Reverb Level)
Sets the amount of the reverberant sound. Higher values
result in louder reverberation.
Value: 0–127
Time (Reverb Time)
Sets the time over which the reverberation will continue.
Higher values result in longer reverberation.
Value: 0–127
Delay Feedback (Reverb Delay Feedback)
This parameter is available when the Reverb Character
(Character) is set to 6, 7 or the Reverb Type (Type) is set to
Delay or Panning Delay. It sets the way in which delays
repeat. Higher values result in more delay repeats.
Value: 0–127
Setting the Reverb Depth of Each
Individual Part
Send Level (Reverb send level)
Sets the amount of the reverb used in each Part.
Value: 0–127
1. Press [EDIT], getting the indicator to light.
2. Use VALUE [-]/[+] to select “Performance Part.”
3. Press [ENTER].
4. Press PART [ ]/[ ] to select the Part.
5. Press the numeric key [8] several times to select “Send
Level”
fig.R06-08
6. Use VALUE [-]/[+] to select the value (0–127).
7. Press [EDIT].
The [EDIT] indicator goes out, and you are returned to
the previous screen.