111
Chapter 7. Creating your original Tone or Drum Set
Chapter 7
Creating a Tone
1. Select the Tone you want to edit.
* When Key Mode is set to Split or Dual, press PART [ ]/
[] to select the Part with the Tone you want to edit.
fig.R07-02
The figure above shows an example where the Upper
Part is selected.
2. Press [EDIT], getting the indicator to light.
3. Use VALUE [-]/[+] to select “Tone/Drum/
PFMCommon.”
4. Press [ENTER].
5. Press the numeric key [1] several times to select the item
you wish to set.
fig.R07-03
* If you hold down [SHIFT] and press [1], you will return to the
previous item.
6. Press [ ]/[ ] to move the cursor to the name’s
first character position.
* Note that when screens other than the Tone Name screen are
displayed, pressing PART [ ]/[ ] switches the Part.
7. Use VALUE [-]/[+] to set the value.
* If you wish to make settings for other Parts, repeat steps 5–7.
8. Press [EDIT].
The [EDIT] indicator goes out, and you are returned to
the previous screen.
Lower Part
Upper Part
Current Part
To Next Page
Loading...
