Roland RS-5 - Error Messages and Message List; Error Message List; Message List

135
Error Messages/Message List
Error Messages/Message List
This section explains the meaning of the various error messages and other messages that the RS-5/9 may display, and describes
the measures to take when these appear.
Error and other messages appearing here are listed in alphabetical order.
Error Message List
fig.Message-01
Cause: There is a mistake in the checksum value for the
received System Exclusive message.
Solution: Correct the checksum value.
fig.Message-02
Cause: The data cannot be processed correctly due to an
excessive number of MIDI messages.
Solution: Reduce the number of MIDI messages being
received.
fig.Message-03
Cause: There is a problem with the MIDI cable
connection.
Solution: Check to make sure no cable has been
disconnected, and that there are no shorts.
fig.Message-04
Cause: MIDI messages could not be received correctly.
Solution: If this same message continues to reappear, it
means that there is a mistake in the content of the
MIDI message.
fig.Message-05
Cause: There is an error in the memory used for storage
of User Area and System Setup data.
Solution: Consult your dealer or local Roland service for
repair.
fig.Message-06
Cause: User Memory data has been corrupted.
Solution: Carry out the Factory Reset operation (p. 21) to
restore the factory settings.
Message List
fig.Message-07
Bulk Dump is in progress.
fig.Message-08
Bulk data is being received. Do not turn off the power.
Processing is canceled.
fig.Message-09
Processing is complete.
fig.Message-10
One or more tones have not been saved. Save the Tone or
Drum Set data before changing the settings, then save the
Performance once more.
fig.Message-11
GM Setup data is being transmitted.
fig.Message-12
GM2 setup data is being transmitted.