Roland RS-5 - Selecting Drum Sets by Specifying the Group and Number

30
Playing the Sounds
Selecting Drum Sets by Specifying the Group and Number
Just as are Tones, Drum Sets are separated into two groups. You can also
select Drum Sets by specifying the group and number.
User
Two Drum Sets can be stored here. You can overwrite these, replacing them
with Drum Sets you create (p. 113).
Preset
This area holds twenty Drum Sets; these cannot be overwritten or replaced.
However, you can change the settings of a currently selected Drum Set, and
then store those settings in User memory.
1–11 are the RS-5/9’s original Drum Sets.
Drum Sets 12–20 provide compliance with GM2.
fig.Q-24a
1
Press [PERFORM/TONE] to call up the Tone/Drum Set
selection screen.
2
Press [TONE CATEGORY] to make the indicator goes out.
The following screen appears.
fig.Q-25exp
3
Press [USER/PRESET] to select the group (User or Preset).
4
Press the numeric keys ([1]–[0]) to specify the Drum Set
number (USER: 1, 2, Preset: 1–20).
4123 5
Should “PERFORM” be
displayed, simply press
[PERFORM/TONE] once
more, and the Tone/Drum
Set selection screen is
displayed.
Drum Set
Group
Drum Set Number
Part
Drum Set
Name
Drum Set
selection screen
Drum Set
Number
If you make a mistake,
press [EXIT] and specify
the number once again.