Roland RS-5 - 02: Overdrive; 03: Distortion

83
Chapter 6. Effect Settings
Chapter 6
02: OVERDRIVE
This effect creates a soft distortion similar to that produced
by vacuum tube amplifiers.
fig.MFX-02
Drive #1
Adjust the degree of distortion. The volume will change
together with the degree of distortion.
Value: 0–127
Level (Output Level)
Adjust the output level.
Value: 0–127
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Amp Type (Amp Simulator Type)
Select the type of guitar amp.
Value
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Pan (Output Pan) #2
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
Value: L64– 63R
03: DISTORTION
This effect produces a more intense distortion than
Overdrive.
fig.MFX-03
Drive #1
Adjust the degree of distortion. The volume will change
together with the degree of distortion.
Value: 0–127
Level (Output Level)
Adjust the output level.
Value: 0–127
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Amp Type (Amp Simulator Type)
Select the type of guitar amp.
Value
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Pan (Output Pan) #2
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
Value: L64– 63R
Amp
Simulator
2-Band
EQ
L in
R in
Over
drive
L out
R out
Pan R
Pan L
L in
R in
L out
R out
Pan R
Pan L
Amp
Simulator
2-Band
EQ
Distortion