Roland RS-9 - 38: Chorus;Delay; 39: Flanger;Delay; 40: Chorus;Flanger

105
Chapter 6. Effect Settings
Chapter 6
Cho Delay (Chorus Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
Value: 0.0–100 [ms]
Chorus Rate
Adjust the modulation speed of the chorus effect.
Value: 0.05–10.00 [Hz]
Chorus Depth
Adjust the modulation depth of the chorus effect.
Value: 0–127
Chorus Bal (Chorus Balance) #1
Adjust the volume balance between the direct sound and the
chorus sound. With a setting of “D100:0W,” only the direct
sound will be output. With a setting of “D0:100W,” only the
chorus sound will be output.
Value: D100:0W–D0:100W
Flg Pre Delay (Flanger Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
Value: 0.0–100 [ms]
Flg Rate (Flanger Rate)
Adjust the modulation speed of the flanger effect.
Value: 0.05–10.00 [Hz]
Flg Depth (Flanger Depth)
Adjust the modulation depth of the flanger effect.
Value: 0–127
Flg Feedback (Flanger Feedback Level)
Adjust the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Value: -98– +98 [%]
Flg Balance (Flanger Balance) #2
Adjust the volume balance between the chorus sound and
the chorus sound that is passed through the flanger. With a
setting of “D100:0W,” only the chorus sound will be output.
With a setting of “D0:100W,” only the chorus sound that
passes through the flanger will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
38: CHORUS/DELAY
This effect connects a chorus and a delay in parallel. The
parameters are the same as for “35: CHORUS → DELAY.”
However, the Delay Balance parameter adjusts the volume
balance between the direct sound and the delay sound.
fig.MFX-38
39: FLANGER/DELAY
This effect connects a flanger and a delay in parallel. The
parameters are the same as for “36: FLANGER → DELAY.”
However, the Delay Balance parameter adjusts the volume
balance between the direct sound and the delay sound.
fig.MFX-39
40: CHORUS/FLANGER
This effect connects a chorus and a flanger in parallel. The
parameters are the same as for “37: CHORUS → FLANGER.”
However, the Flanger Balance parameter adjusts the volume
balance between the direct sound and the flanger sound.
fig.MFX-40
R in R out
L in L out
Feedback
Balance W
Balance D
Balance W
Balance D
Chorus
Delay
R in R out
L in L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
Flanger
Delay
R in R out
L in L out
Feedback
Balance W
Balance D
Balance W
Balance D
Chorus
Flanger