Roland RS-9 - Turning the Power off; Adjusting the Display Contrast (LCD CONTRAST)

16
Getting Ready
4
Play the RS-5/9’s keyboard and gradually raise the volume
controls of the RS-5/9, or the connected audio equipment to an
appropriate volume level.
fig.Q-03
Turning the power off
1
Before you turn off the power, make sure of the following points.
• Are the volume controls of the RS-5/9 and the other connected
equipment turned to the minimum position?
•Have you saved the sounds or other data you’ve created? (p. 113)
2
Turn off the power for all connected audio devices.
3
Turn off the RS-5/9 power switch.
Adjusting the display contrast
(LCD CONTRAST)
The characters in the display may be difficult to view immediately after
turning on the power or after extended use; this may also be because of
where and how the display is situated. Follow the steps below to adjust the
display’s contrast.
fig.Q-04
Turn up the RS-5/9’s
volume level carefully.
Excessive volume can
damage connected audio
devices, your hearing, or
annoy your neighbors.
The LCD CONTRAST
setting affects the RS-5/9 as
a whole (i.e., is a system
setting). This setting
remains stored in memory
even while the power is off.
342,5 1,6