Roland RS-9 - 11: Hexa-Chorus; 12: Tremolo Chorus

88
Chapter 6. Effect Settings
11: HEXA-CHORUS
Hexa-chorus uses a six-phase chorus (six layers of chorused
sound) to give richness and spatial spread to the sound.
fig.MFX-11
Pre Delay (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
Value: 0.0–100 [ms]
Rate #1
Adjust the rate of modulation.
Value: 0.05–10.00 [Hz]
Depth
Adjust the depth of modulation.
Value: 0–127
Pre Delay Dev (Pre Delay Deviation)
Pre Delay determines the time from when the direct sound
begins until the processed sound is heard. Pre Delay
Deviation adjusts the differences in Pre Delay between each
chorus sound.
Value: 0–20
Depth Dev (Depth Deviation)
Adjust the difference in modulation depth between each
chorus sound.
Value: -20– +20
Pan Dev (Pan Deviation)
Adjust the difference in stereo location between each chorus
sound. With a setting of 0, all chorus sounds will be in the
center. With a setting of 20, each chorus sound will be spaced
at 60 degree intervals relative to the center.
Value: 0–20
Balance (Effect Balance) #2
Adjust the volume balance between the direct sound and the
chorus sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
chorus sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
12: TREMOLO CHORUS
Tremolo Chorus is a chorus effect with added Tremolo
(cyclic modulation of volume).
fig.MFX-12
Pre Delay (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
Value: 0.0–100 [ms]
Chorus Rate
Adjust the modulation speed of the chorus effect.
Value: 0.05–10.00 [Hz]
Chorus Depth
Adjust the modulation depth of the chorus effect.
Value: 0–127
Tremolo Phase
Adjust the spread of the tremolo effect.
Value: 0–180 [deg]
Tremolo Rate #1
Adjust the modulation speed of the tremolo effect.
Value: 0.05–10.00 [Hz]
Tremolo Sep (Tremolo Separation)
Adjust the spread of the tremolo effect.
Value: 0–127
Balance (Effect Balance) #2
Adjust the volume balance between the direct sound and the
tremolo chorus sound. With a setting of D100:0W only the
direct sound will be output, and with a setting of D0:100W
only the tremolo chorus sound will be output.
Value: D100:0W–D0:100W
Balance W
Balance W
L in
R in
L out
R out
Hexa-Chorus
Balance D
Balance D
Tremolo Chorus
L in
R in
L out
R out
Balance D
Balance D
Balance W
Balance W