Roland RSS M-300 - Page 101

101
Effects
Effects
Current output-destination indication
This indicates the current output-destination channel.
If more than one output-destination channel are exist, the
lowest number channel is shown.
The function buttons have the following operations:
Effects such as reverb and delay are typically used in a send/
return configuration.
Here we will explain the procedure for using FX3 as a send/return
type effect using AUX7 and CH27–28.
Specifying the effect input-source
1.
Access the EFFECTS screen.
2.
Move the cursor to the FX INSERT/SOURCE SELECT popup
button L for FX3, and press [ENTER].
The FX INSERT/SOURCE SELECT popup will appear.
3.
Press [F4 (AUX OUT)] to access the AUX OUT tab.
ig.ScrFXInSel2.eps
4.
Move the cursor to the AUX7 button, and press [ENTER]
to select it.
5.
Press [F8 (CLOSE)] to close the popup.
6.
In the same way as you did in steps 1 through 5, select
AUX7 as the input-source for the R side of FX3.
Specifying the effect return channel
1.
Access the EFFECTS screen.
2.
Move the cursor to the FX DESTINATION SELECT popup
button L for FX3, and press [ENTER].
fig.ScrFXOutSel2.eps
The FX DESTINATION SELECT popup will appear.
3.
Move the cursor to the CH27 button, and press [ENTER]
to select it.
4.
Press [F8 (CLOSE)] to close the popup.
5.
In the same way as you did in steps 1 through 5, select
CH28 as the output-destination for the R side of FX3.
Here we will explain the procedure for inserting the L side of FX1
into CH1.
1.
Access the EFFECTS screen.
2.
Move the cursor to the FX INSERT/SOURCE SELECT popup
button L for FX1, and press [ENTER].
The FX INSERT/SOURCE SELECT popup will appear.
3.
Press [F1 (CH 1–32 INSERT)] to access the CH 1–32 INSERT
tab.
fig.ScrFXInSel.eps
4.
Move the cursor to the CH1 button, and press [ENTER] to
select it.
5.
Press [F8 (CLOSE)] to close the popup.
If you want to insert the effect into both channels of a stereo-linked
pair, make insert settings for both the L and R sides.
[F8 (CLOSE)] Closes the popup.
Using an effect via send/return
3
Inserting an effect into a channel
M-300_e.book 101 ページ ２０１０年６月２４日 木曜日 午後２時２６分