PATCH SETUP
1. Press the [COMP] button and [PLAY] button to make them light. (both buttons calls the “SETUP”)
2.
Use the [1] – [16] buttons to select a parameter, and use the [VALUE] knob to edit the parameter’s value.
The main
display will indicate the value set.
BUTTON PARAMETER VALUE Explanation
[1] PITCH BEND RANGE
(semitone units)
0-24
[2] MOD WHEEL DEPTH 0-127
[3] LFO AFTERTOUCH 0-127
[4] VCF AFTERTOUCH 0-127
[5] CONTOUR DEPTH 0-127
[6] PATCH VOLUME 0-127
[7] PWM LFO RATE 0-127 Adjusts the rate of the PWM LFO. (Added in V1.10)
[8] PWM LFO DEPTH 0-127 Adjusts the depth of the PWM LFO.(Added in V1.10)
[9] PATCH CLEAR Allow to clear a patch
[15] CV FINE TUNE 0-255 Finely adjusts the pitch relative to the voltage that is input to the
CV INPUT jack. (Added in V1.04)
[16] CV KEY FOLLOW 0-255 Adjusts the width of pitch change relative to the voltage that is
input to the CV INPUT jack. (Added in V1.04)
IMPORTANT NOTES:
PWM LFO: This dedicated LFO is a triangle wave that modulates the pulse width of all 3
oscillators (OSC 1–3). If a waveform other than pulse wave is selected, modulation is not applied.
Adjusting the CV INPUT jack’s key follow setting will cause the tuning to change slightly. For this
reason, you should adjust key follow first, and then use fine tune to specify the overall pitch. There
is no need to execute the Write operation. CV Fine Tune and CV Key Follow are saved as settings
for the entire system.
Page 20 of 35 Manual V1.03 for firmware V1.11
To Next Page
Loading...
