Roland SH-32 - Playing a Rhythm Set: Selection and Playback

25
Producing Sound
Quick Start
Playing a Rhythm Set
Apart from general synthesizer sounds, the SH-32 also has four Rhythm Sets. By
using the onboard Arpeggiator (p. 36, p. 74), you can play a loop of simple rhythm
patterns.
fig.007
1
Press [BANK].
[BANK] lights up, and [1/A]–[4/D], [8/R] blink.
2
Press [8/R].
You can select a Rhythm Set.
3
Press [1/A]–[4/D] to select a Rhythm Set number.
The selected Rhythm Set number is shown in the display.
r1U, r2U: User Rhythm Sets (can be overwritten)
r3P, r4P: Preset Rhythm Sets (cannot be overwritten)
4
Use the Preview function (p. 21), or a MIDI keyboard to play some
sounds.
The selected Rhythm Set will be heard.
See “Rhythm Sets (r1U, r2U,
r3P, r4P)” (p. 45) for details on
Rhythm Sets.
Display
13 2
In step 1, if all of the buttons
from [1/A] through [8/R] are
b
linking after you press
[BANK], you will need to press
[PATCH/PERFORM] to turn
them off, then press [BANK]
again (Patch mode p. 20).
When a Rhythm Set number is
shown in the display, you can
also press [VALUE ▼/▲] to
select a Rhythm Set.