6. Installing the Blade
34
3.
Install the blade holder.
Loosen the screw shown in the gure.
Support the screw from below and insert the blade holder.
Tighten the screw.
Tug the blade holder upward to make sure it does not come loose.
Close the front cover, then press .
Important Note on the Handling and Use of the Cutting Carriage
Leave the cutting-carriage screw loose when no blade holder is installed. Keeping the screw tightened causes the blade-
holder insertion hole to become gradually smaller, making installation dicult.
Insert until the
collar is ush with
the surface.
Screw
Support it from below.
Screw
To Next Page
Loading...
