Roland SR-20HD - Other Features; Settings Management

42
Other Features
NOTE
¹ When using a SD card for the rst time, you must format it using
the SR-20HD (p. 7).
¹ Never turn o the power or remove the SD card while the message
“Processing...” is shown.
¹ Depending on the SD card, recognition of the SD card might take
some time.
Saving
Saving a new le
1. [MENU] button Ó “SD card/USB Memory” Ó select
“Save Setting as”, and then press the [VALUE/CURSOR]
knob.
A conrmation message appears.
If you want to cancel the operation, select “Cancel”.
2. Turn the [VALUE/CURSOR] knob to select “OK”, and
then press the [VALUE/CURSOR] knob.
When the operation is nished, the message “Completed” appears.
3. Press the [VALUE/CURSOR] knob to close the message.
4. Press the [MENU] button to quit the menu.
Content that is not saved to the le
¹ The System menu settings “Test Pattern”. The unit always starts with
this “O”.
¹ The still images loaded into the unit. Only the le names of the still
images are saved.
¹ The state of the [ON AIR] button. The unit always starts with this lit.
¹ The state of the AUDIO FUNCTION button to which the audio player
is assigned. This is always o when the unit starts up.
¹ The positions of the volume knobs and faders.
Overwrite-saving
1. [MENU] button Ó “SD card/USB Memory” Ó select
“Save Settings”, and then press the [VALUE/CURSOR]
knob.
The settings les in the SD card are listed.
2. Turn the [VALUE/CURSOR] knob to select the setting le
to overwrite, and then press the [VALUE/CURSOR] knob.
A conrmation message appears.
If you want to cancel the operation, select “Cancel”.
3. Turn the [VALUE/CURSOR] knob to select “OK”, and
then press the [VALUE/CURSOR] knob.
When the operation is nished, the message “Completed” appears.
4. Press the [VALUE/CURSOR] knob to close the message.
5. Press the [MENU] button to quit the menu.
Loading
Here’s how to load this unit’s settings that you saved on a SD card.
When you load settings, the current settings are overwritten.
1. [MENU] button Ó “SD card/USB Memory” Ó select
“Load Settings”, and then press the [VALUE/CURSOR]
knob.
The settings les in the SD card are listed.
2. Turn the [VALUE/CURSOR] knob to select the setting le
to recall, and then press the [VALUE/CURSOR] knob.
A conrmation message appears.
If you want to cancel the operation, select “Cancel”.
¹ When you select “System Only”, only the Network, Stream, Record
and System settings can be recalled.
3. Turn the [VALUE/CURSOR] knob to select “OK”, and
then press the [VALUE/CURSOR] knob.
When the operation is nished, the message “Completed” appears.
4. Press the [VALUE/CURSOR] knob to close the message.
5. Press the [MENU] button to quit the menu.
Saving Internal Settings to an SD Card
You can save the settings of this unit as a single le (.sr20) to a SD card. You can use the saved settings le by loading it from the USB ash drive
into this unit when necessary.