Roland Super JX-10 - Page 13

d. Voice
Memory Switch
@
This
switch selects which memory mode; the
JX-
10's
interna!
memory or the Cartridge
memory
to
be used.
a
CART
INT
Patch
Memory
You can call a Patch
Memory in the Cartridge
You
can call a Patch
Memory in the
JX-10
Tone
Tone Numbers
1 to 50
=
Tones
in the
Cartridge
Tone
Number
1 to 50
=
Tones in the JX-10
Tone
Number
51 to TOO
=
Tones in the JX-10
*
Even
after you have changed the Memory
modes with
the
Voice
Memory Switch, the new
position does not affect
the
memory unless you
select
a
new
Patch Memory.
When
you
select
a new Patch Memory,
"
I
"
(internal) or
"
C
"
(cartridge) is shown at the left
end of the Display, depending on which position
has been
selected with the Voice Memory
Switch.
*
When
the Memory Cartridge is not connected,
be sure to
set the
Voice Memory Switch
to
the
INT position.
13