(3)
Set the
Voice Memory
Switch0to the
approp-
riate position
depending on
which of the JX-
10's
memory or Cartridge
memory to be
used
for the new location, then
assign the
Bank and
the Number
of
the
new location
using the
Patch IVlemory
Buttons®.
(g)
Push
the Enter Key.
The Display will respond with as below,
showing
that the writing is completed, then
return to the
usual indication.
(
jr/TT
TCh' oorru
I
I f
i i_ti
Return the
Protect Switch
to the ON position.
b. Writing
a Tone
The Tones
of 51 to TOO in the JX-lO's internal
memory
cannot be
rewritten. Other
Tones
(1
to 51
in the internal
memory and all 1 to 50 Tones in the
cartridge)
can be rewritten.
Right after
you have edited the Tone (with the indi-
cator of
the TONE lighted),
take the following writ-
ing operation.
(i) To write the edited Tone into the
JX-10's internal
memory, set the
Protect Switch on the JX-1
to
the OFF position. To write onto
the Cartridge
Memory,
set the Protect Switch on the car-
tridge to
the OFF position.
©
Push
the Write Button
Qj)
.
The Display
will respoond with:
I tCiTTC:
c«M
J.
f
(_
TOh ir
TD
^^^^ I^
A: Internal
or Cartridge
B:
Tone Number of the
Patch
Memory currently
selected
42
To Next Page
Loading...
