Roland Texart RT-640 - Using Sticky Media

Accommodating Different Media Types and Conditions
4
Advanced Functions
98
Description
In the following cases, ink tends to collect on the surface of the print heads. Under some conditions, this ink
may be transferred to the media or cause dot drop-out.
 When you use media prone to buildup of static electricity.
 When the ambient temperature is low.
 When the print-head height is set to “HIGH.”
If "PAGE," "PRDC CL. (JOB)," or "PRDC CL. (TIME)" is selected, ink buildup is removed before or during printing.
Using these settings results in longer printing times.
Default Setting
[PERIODIC CL.]: NONE
Using Sticky Media
Procedure

Press .

Press several times to display the screen shown
at left.
Press
.

Press several times to display the screen shown
at left.
Press
.

Press or to select "ENABLE."
Press
to conrm.

Press to go back to the original screen.
Description
Some types of media may tend to stick to the platen. Starting printing with the media sticking to the platen
may make normal media feed impossible and cause the media to jam. When using such media, set the [MEDIA
RELEASE] menu item to "ENABLE." This peels o the media before starting printing if it is stuck to the platen.
Note, however, that media feed may be unstable when printing is performed after executing this operation.
Leave this menu item set to "DISABLE" unless you specically need to change it.
Default Setting
[MEDIA RELEASE]: DISABLE
/'07
57$/'07
57$/'07
/'&+#4'.'#5'
/'&+#4'.'#5'
&+5#$.''0#$.'