Roland Texart RT-640 - Displaying the Amount of Media Remaining

Printing Operation Management
5
To Administrators
103
Description
When “STOP” is selected, printing pauses and so colors may be uneven. Ensure a sucient amount of remain-
ing ink before you begin printing.
When “CONT” is selected, printing does not stop even if ink runs out completely. To replace an ink pouch, wait
until printing ends or press
to pause printing.
Default setting
[EMPTY MODE]: STOP
Displaying the Amount of Media Remaining
You can display how much of the media in use is left. By setting the amount of media currently remaining
at the start, the amount remaining will be constantly displayed on the display screen until it reaches zero.
Procedure

Press .

Press to display the screen on the left.
Press
, then .

Press .

Press or to set the current amount of
media remaining.
Press
to conrm.

Press to go back to the original screen.
Description
If you cancel media loading, for example by removing the media or raising the loading lever, the amount
remaining at that time ashes on the screen.
Because the amount of media remaining is not updated automatically when you change the media, redo the
setting whenever you change the media. You can also set the machine to display this menu automatically
whenever you change the media. See the next section, "Making Sure to Verify the Setting for the Amount
Remaining Every Time the Media Is Changed."
Note: The remaining amount that is displayed is only an estimate, and its accuracy is not assured.
/'07
5*''64'/#+0
5*''64'/#+0
5'6.'0)6*
5'6.'0)6*
OO
9OO ޓ 㧶O
ޓޓ

5'6725*''6
ޓޓޓޓޓ
㧶ޓO
This display is updated.
If media has not been loaded,
the set value ashes.