Other Problems
The Machine Does Not Move
Is the cable connected?
Connect the cable securely.
"Setup Guide"
Is the power switched on?
Switch on the machine's main power, then press the sub power switch and make sure the sub power switch
lights up.
P. 17"Switch On!"
Is a cover open?
Close the front, left, and right covers.
Is illuminated?
Printing is not performed when is not illuminated. Lower the loading lever.
P. 47"Getting Ready to Receive Data from a Computer"
Is the top menu displayed?
Top menu
If the top menu is not displayed, printing does not start even when data is sent from the computer. To go to
the top menu, press
, then press .
P. 47"Getting Ready to Receive Data from a Computer"
Is a message displayed on the screen?
P. 122"A Message Appears", P. 123"An Error Message Appears"
Is illuminated?
When lights up, operation is paused. To resume, press . goes dark and printing
resumes.
P. 49"Pausing or Canceling Printing"
Has ink run out?
When the screen shown above is displayed, print data cannot be accepted.
If the screen shown above is displayed during printing, the behavior of the machine depends on the [EMPTY
MODE] setting. (Only when 8 colors are selected)
When "STOP" is selected: Printing operation is paused.
When "CONT." is selected: A warning beep sounds, and printing continues until the machine has nished
printing the print data it has accepted. In this case, it is also possible to press
and pause printing.
9OO
ޓޓ
To Next Page
Loading...
