Roland Texart RT-640 - Cannot Cut off the Media; It Is Not Possible to Check the Amount of Discharged Fluid in the Drain Bottle

Other Problems
6
FAQ
121
In both cases, the error can be resolved by replacing the ink pouch with a new one. If there is print data that has
not yet been printed remaining in the machine, printing resumes. If there is unsent print data in the computer,
printing resumes when the data is resent.
 P. 102"Determining What Happens When Ink Runs Out (Only When 8 Colors are Selected)", P. 55"Ink Pouch Re-
placement"
When using the media take-up system (TUC-3), did you move the media by holding
down ?
When using the separately available media take-up system (TUC-3), if you move the media by holding down
, the machine stops for a xed interval to protect the motor. If you wait for around 5 seconds you
will be able to resume operation.
Is the network routing appropriate?
Try connecting the computer and the machine to the same hub, or connecting them directly using a crossover
cable. If this makes it possible to perform printing, it means the problem is in the network itself.
Are the network settings correct?
If the cable connections are secure and no problem is found in the network itself, make sure that the IP ad-
dress and other such settings are appropriate. The settings on both the machine and the computer must be
appropriate. Redo the settings, checking to ensure that the IP address does not conict with the IP address
for another device on the network, that the port setting for the software RIP species the IP address set on
the machine, that the settings have no typing errors, and for other such problems.
 "Setup Guide," P. 107"Viewing Information about the System of This Machine"
Did the software RIP end abnormally?
Make sure the software RIP is running correctly, then switch the machine's sub power switch o and back
on. For information about using the software RIP, refer to the documentation included with the software RIP.
Cannot Cut Off the Media.
Is the separating knife mounted?
If the separating knife is not mounted, you cannot cut o the media.
 P. 82"Replacing the Separating Knife"
Are the cut rail mounted?
If the cut rail is not mounted, you cannot cut o the media.
 P. 82"Replacing the Separating Knife"
It is not Possible to Check the Amount of Discharged Fluid in the Drain Bottle
Is ink splattered around the inside of the drain bottle?
If ink is splattered around the inside of the drain bottle, it may not be possible to check how much discharged
uid the bottle contains.
P. 121"It is not Possible to Check the Amount of Discharged Fluid in the Drain Bottle"