124
[SHEET SET ERROR SET AGAIN]
The loading lever was lowered while no media was loaded
Raise the loading lever, load the media in the correct position, then lower the lever again.
P. 18"Loading Media"
[SHEET TYPE] is set to "OPAQUE," but transparent media was loaded
Raise the loading lever, set the [SHEET TYPE] menu item to "CLEAR," then reload the media.
P. 92"Using Transparent Media"
The loaded media is too small
Press any button on the operation panel to clear the message. Replace with media of usable size.
[DATA ERROR CANCELING...]
Printing was stopped because a problem was found in the data received.
Operation cannot be continued. Check for a problem with the connector cable or the computer, and redo the
operation from the step of loading the media.
[CLEANING ERROR]
Light choke cleaning was stopped due to some kind of operation.
The ongoing task cannot be continued. Switch the sub power o by holding down the switch for one second
or longer, and then back on. Then perform the [LIGHT CHOKE CL.] from the beginning.
P. 62"Light Choke Cleaning"
[CANCELED FOR PUMP PROTECTION]
The printer made an emergency stop because the following state has continued for 10
minutes or longer while cleaning (normal, medium, powerful, super, light choke cleaning,
subtank refresh, or automatic cleaning while sub power was switched off) was in progress
or during the rst ink lling procedure for the machine.
The machine ran out of ink
Operation cannot be continued. Switch o the sub power. After you switch o the power, contact the autho-
rized Roland DG Corp. dealer where you purchased the machine or Roland Corp.
[AVOIDING DRY-UP TURN POWER OFF]
The print heads were forced to the home position to prevent them from drying out.
Operation cannot be continued. Switch the sub power o, then back on.
[SET HEAD HEIGHT TO xxx]
The height of the print heads is lower than the height specied in the software RIP.
This warning indicates that the height of the print heads is too low for the media thickness specied in the
software RIP. The print-head carriage moves to a location where you can operate the height-adjustment lever.
Adjust to the displayed height, then press
.
P. 91"Adjusting Print Head Height to Match Media Thickness"
[MOTOR ERROR TURN POWER OFF]
A motor error occurred.
Operation cannot be continued. Switch o the sub power. Next, eliminate the cause of the error, then im-
mediately switch on the sub power. If the machine is allowed to stand with the error uncorrected, the print
To Next Page
Loading...
