20
Hold the outer side of the media holder (Left) and position the left edge of the media
to align with the marks.
When deciding the position, hold the both sides of media holders from the outer sides and move it. Do
not hold the media directly to move.
CAUTION
Do not hold places other than those instructed.
Otherwise the media may fall off the media holder and cause injury.
How to use media anges for paper tubes (cores) with an internal diameter of 2 inches
Note: Media anges for paper tubes (cores) with an internal diameter of 2 inches are optional items.
Decide the left and right side positions of the media nally at this step.
After this procedure is completed, if the left and right side positions do not t the proper position
when securing the media with pinch rollers, go back to this step to redo this procedure. If you attempt
to forcibly readjust the position of the media simply by pulling on the media itself, printing quality
will be aected due to skewed media feed.
Marks
Media anges for
2-inch media
Insert pin
Align projections
Remove pin
If pin is dicult to re-
move, use lineman's
pliers, etc.
End cap
To Next Page
Loading...
