Roland Texart RT-640 - Printing Process

Setup of Media
2
Basic Operation
42

Use and to set the correction value.
Press
to conrm.

To conrm again/adjust again
Press
to select [Execute].
Press
to conrm.
The test pattern of bidirectional correction is printed again. Go back
to step

and set again.
To go to the next after correction is completed
Press
to select [Finish].
Press
to conrm.
For the individual setting method of this setting item and the description, refer to  P. 88"Correcting for
Misalignment in Bidirectional Printing"
5. Saving the setting as preset

Press to select [Save].
Press
to conrm.
If you select [Next], the screen in step

is displayed, and the settings
you have selected up to this point are not saved as a preset. However,
they will remain as the current settings values for the machine.

Press or to select a destination to save
the preset.
You can select one of NAME1 to 8.
Press to conrm.

Press or to select a character.
Press
to move to the next character.
Select the following characters in the same way.
You can enter up to15 characters.
Press to conrm.
#&,756$+&+4

To decide a correction value
Choose the value that produces the least misalignment of the 2 lines. When wavering between
two numbers, select half value.
-20 -19 -18 -17 -16 -15 -14 -13 -12 -11 -10 -9 -8 -7 -6 -5 -4 -3 -2 -1 0 +1 +2 +3 +4 +5 +6 +7 +8 +9 +10 +11 +12 +13 +14 +15 +16 +17 +18 +19 +20
4'&1#&,!
=;'5?&10'
24'5'6
=5#8'?0':6
5#8'61
0#/'
5'60#/'
Current correction value
Value to be set
The least misalignment
= Current correction value