Roland Texart RT-640 - Replacing the Felt Wiper

Replacing Consumable Parts
3
Maintenance
79
Replacing the Felt Wiper
The felt wiper is a part used for cleaning the print heads. When the screen shown below is displayed on the
display screen, it is time for replacement. Replace it with a new item.
For information about purchasing felt wipers, contact your authorized Roland DG Corp. dealer.
CAUTION
Be sure to perform operations as specied by the instructions above,
and never touch any area not specied in the instructions.
Failure to observe these precautions may cause the machine to move sud-
denly, resulting in injury.
1. Enter the felt wiper replacement menu.

When the screen on the left is displayed, press .

Remove any media.

Press .

Press several times to display the screen shown
at left.
Press
, and then press twice.

Press .
Press
.

Press .
The print-head carriage moves to a location where felt wiper replace-
ment is possible, and then the screen shown on the left appears.
6+/'(14
('.64'2.#%'
Required items
6+/'(14
('.64'2.#%'
/'07
57$/'07
57$/'07
/#+06'0#0%'
/#+06'0#0%'
4'2.#%'('.6
12'0%18'44
Felt Wiper Tweezers