Roland Texart RT-640 - Replacing the Separating Knife

Replacing Consumable Parts
3
Maintenance
82
Replacing the Separating Knife
If the separating knife becomes dull, replace it with the included replacement knife.
CAUTION
Be sure to perform operations as specied by the instructions above,
and never touch any area not specied in the instructions.
Failure to observe these precautions may cause the machine to move sud-
denly, resulting in injury.
CAUTION
Do not touch the edge of the separating knife.
Doing so may result in injury.
1. Enter the separating knife replacement menu.

Remove any media from the platen.

Press .

Press several times to display the screen shown
at left.
Press
, and then press twice.

Press .

Press several times to display the screen shown
at left.
Press
.
The print-head carriage moves to a location where knife replacement
is possible, and then the screen shown on the left appears.

Open the front cover.
Preparations are complete when this screen appears.
Required items
/'07
57$/'07
57$/'07
/#+06'0#0%'
/#+06'0#0%'
4'2.#%'-0+('
019241%'55+0)
12'0(4106
%18'4
(+0+5*'&!
Replacement blade for separating
knife